Restoring OEM seams is an art in itself. But with our TEROSON® Seam Sealing system it is actually easy to replicate the original OEM structure. Learn everything you need to know about  seam sealing in vehicle body repair from the use of standard beads to reproduction of OEM textures.

Get the Materials

In vehicle repair it is crucial to reproduce the same quality and visual appearance provided by the original OEM seams to avoid corrosion. With the below instruction you can recreate traditional textured seams with spray seam sealing /spray surface coating.


All repair and maintenance tasks shown should be done by professionals only. Please do not try this at home or if not qualified by professional education. Always follow car manufacturer's instructions.
Limitation of liability

STEP 1

Preparation Cartridge

Remove bottom cover and open cartridge. Screw dispensing nozzle (inner nozzle) onto cartridge.

STEP 2

Screw on second part of spray nozzle

Insert the cartridge into the spray gun and screw on blue screw cap. Attach second part of spray nozzle on top.


STEP 3

Using the air gun

Adjusting the compressed air gun and the screws — the supply pressure must be at least 6 bar (max. 10 bar). Start the closed sealant flow and open air flow completely. Position gun towards the substrate and press trigger. Slowly open sealant flow to get base structure (different ratios of sealant and air supply will produce the required texture).

STEP 4a

Spray seam sealing

Hold the nozzle in the vertical position and move at a right angle to the seam about 4 cm above the surface. In case of overspray adjust distance. Let the product cure.

STEP 4b

Spray surface coating

For coating larger areas adjust distance to the surface of approx. 20 cm. Let the product cure.

Frequently Asked Questions

ANSWERS TO YOUR MOST COMMON QUESTIONS

Limitation of Liability

The information provided herein, especially recommendations for the usage and the application of our products, is based upon our knowledge and experience. Due to different materials used as well as to varying working conditions beyond our control we strictly recommend to carry out intensive trials to test the suitability of our products with regard to the required processes and applications. We do not accept any liability with regard to the above information or with regard to any written or verbal recommendation, except if otherwise explicitly agreed and except in relation to death or personal injury caused by Henkel´s gross negligence or intention and any liability under any applicable mandatory product liability law. Please note that the information provided by us may not be current, complete and correct. It is not intended to serve as legal advice. Each user is solely responsible for assessing and ensuring compliance with any applicable law. The information is protected by copyright. In particular, any reproductions, adaptations, translations, storage and processing in other media, including storage or processing by electronic means, enjoy copyright protection. Any exploitation in whole or in part thereof shall require the prior written consent of Henkel Nederland bv. Except as otherwise noted, all marks used in this sell sheet are trademarks and/or registered trademarks of Henkel and/or its affiliates.